Reply With Quote
Dot - Com
PricelessTry NPD (National Parts Depot), if they don't have them, I'm sure they will know where you can get them......hope this helps.
The driver's seat on my '70 Mach 1 doesn't move back far enough to be comfortable.
I have been told that extended seat rails are available. The rails utilize the existing anchor bolt locations.
Where can I find these extended seat rails for my '70?
Stan
Try NPD (National Parts Depot), if they don't have them, I'm sure they will know where you can get them......hope this helps.
MCA Certified Judge in: First Generation classes (64.5-70)
Long time MCA member(27 yrs.) MCA #17780
1969 Mach 1, owned 43 yrs.
1967 Mustang, owned 33 yrs.
I was reading about a Ford Technical Service Bulletin (TSB 269) that described a method to move the seat back.
Does anyone have a copy - old threads date back to 2005.
Here's the TSB. I did something similar in my '67 but used a piece of flat stock steel 1/4" thick X 1" wide to mount foxbody seats that will be recovered to match my orignal rear seats.
Jon
'67 Coupe - Candyapple red deluxe ext, Deluxe red/maroon int, 289 Stroked to 333ci, AOD, 9" 3.50:1, front PDB.
'09 Warriors In Pink - wife's car, Susan G. Komen Edition 1 of 199 built. Fender emblems, rose pink hood striping, rocker ribbon stripe, charcoal leather stiched in pink, ribbon floor mats, billet grille w/o emblem.
Hey - I recognize that scanOriginally Posted by JonK67
LOL
Posting Permissions
Bookmarks