Replacing molding and emblem on 64.5 Mustang

[davecc1]

On my 64 1/2, the rocker panel molding and the Mustang emblem near the front wheel well are both faded and in need of replacement. The emblem (with the red, white and blue bar) doesn't seem to be easily accessible from the wheel well. Any instructions/tips for replacing? And would NPD be a good source for new ones?

[carlite65]

the emblem is just pressed into place. put a piece of fishing line behind it and pull it off. NPD is a very reputable parts source. also checkout vitginia classic mustang.

[davecc1]

the emblem is just pressed into place. put a piece of fishing line behind it and pull it off. NPD is a very reputable parts source. also checkout vitginia classic mustang.

How does the rocker panel molding attach? (I don't have easy access to the car right now). Thanks.

[carlite65]

there is nut inside each wheelwell at each end of the molding. remove those. then the moulding just pops off the clips. 5 per side. use a wide plastic tool to pry.